modded game gear SEGA Game Gear Replacement Screen

modded game gear SEGA Game Gear Replacement ScreenA new backlight LCD kit upgrade for your SEGA Game Gear. FEATURES: Touch controls to change between 8 color modes, scan line effect, and 3 aspect ratios. Supports both the 1 chip and 2 chip versions. Power efficient. Built in SDRAM cache in the chip. Adjust brightness via the thumbwheel. Supports VGA output (Connector not included) Does Not support Majesco VA4 VA5 models The motherboard with the "MADE IN TAIWAN" logo on it is not supported. Supports

A new backlight LCD kit upgrade for your SEGA Game Gear. 

FEATURES:

• Touch controls to change between 8 color modes, scan line effect, and 3 aspect ratios. 
• Supports both the 1 chip and 2 chip versions. 
• Power efficient.
• Built-in SDRAM cache in the chip.
• Adjust brightness via the thumbwheel.
• Supports VGA output (Connector not included)
• Does Not support Majesco / VA4 / VA5 models
• The motherboard with the "MADE IN TAIWAN" logo on it is not supported.
• Supports single chip motherboard: 1 ASIC PCB VA1 revisions 837-9130 / 837-9024 / 837-8560 and dual chip motherboard: 2 ASIC PCB VA0 revisions 837-7996 / 837-7719-01 /837-7398-03

INCLUDED:

• 1x 3.5 Inch Backlight TFT LCD
• 1x PCB
• 2 x FPC connect cables. (In case one breaks)
• 1x Double-sided tape
• 5x 10pF capacitors
• 6x 0 Ohm resistors
• 2x 200Ohm resistor
• Red hook up wires

DOCUMENTATION:

• User Guide Video
• 1 Chip Install Guide

• 2 Chip Install Guide

CONTROLS:

• Press 'START+1+2' to turn VGA output on or off.
• Touch the 'left touchpad' to change the color modes.
• Touch and hold the 'left touchpad' 3 seconds to turn 'scan line' on or off.
• Touch and hold the 'right touchpad' and 'left touchpad' 3 seconds to change the image aspect.

NOTES:

• Some SEGA shells have a metallic coating on the inside and this metallic coating on the plastic is conductive. It can cause the color modes and/or aspect modes to cycle automatically. To avoid this issue, please scrape off the metallic coating and put the touch sensors directly on the plastic. You can also follow this guide to further reduce touch sensor sensitivity. 

WARNINGS:

• Test before installation! When you receive a backlight/LCD kit, you should perform a dry run before installing to assure that nothing has been damaged in transit. A dry run or test fit means the kit is not installed in the shell. This includes the use of adhesives, brackets, and any performed soldering. All ribbon cables should have no bends or creases in them. If you are unsure how to perform a dry run, please contact our support team and we will be happy to help. Backlight kits that have been installed are not eligible for replacement or return.
• LCD may break if put under too much pressure or dropped. Please exercise extreme caution when installing.